Hi
I'm busy setting up some thermostat controllers for my snakes heating requirements but I'm getting a little stuck on the section for the wiring of the load that the controllers will carry.
Here is a pdf of the manual for the controllers that I'm installing:
http://www.coolsense.co.za/pshop/attach ... achment=59
The wiring diagrams show two models, the EVK421 and the EVK402, mines the EVK402.
I've spoken to a couple electricians but I just don't have confidence in their answers. They don't seem 100% sure when they answer me.
So my questions are; do I bring the live wire (220v) in to point 1 and then run live to my heat emitter (a 60w ceramic heat emitter) from point 2? or point 3?
I assume my neutral does not get connected anywhere here? The thermostat is purely just a switch, therefore neutral has nothing to do with it?
Neutral will run directly from the power source to the heat emitter?
I'm not using an alarm so point 5 is of no consequence to me.
Shottie